Finished with Bona oil-based polyurethane. Provides long-lasting beauty and protection to any interior wood surface. The tops look stunning when wiped with mineral spirits; that's the look I want. Whats the best way to make the grain pop with kiln dryed walnut. Water-based polyurethane is able to be used for finishing hardwood floors. Both water- and oil-based polyurethane are varnishes, and they dry to a naturally glossy finish. Minwax® Fast-Drying Polyurethane is a clear, oil-based, durable protective finish. Wet-Sanded Tung Oil Varnish: Augments Natural Contrast in Walnut + Fills Grain. Polyurethane comes in many ranges according to flexibility and toughness. There are many ways to preserve and protect wood, but a clear coat of polyurethane will accomplish the task without hiding the natural elegance and intricacy of the wood itself. I have a couple end tables with walnut tops I completed some time ago, but have not finished yet. To some degree, this method is … The product dries to an evened-out, low-sheen finish, and as soon as it cures, which could take up to a month, it becomes rock-hard – a must-have feature if you want a tabletop that’s able to withstand daily wear and tear. Seal the surface with polyurethane if you want to keep things simple. Can be used on both finished and unfinished wood. What is the best way to "pop" the grain under polyurethane? For a list of specific food safe finishes that I recommend, please take a look at this page. Ideal for woodwork, furniture, doors, cabinets and floors. First one up is the General Finishes Water-Based Urethane Topcoat. Don’t let the name confuse you – we’re still talking about polyurethane coatings here!. For that reason, I've decided to use polyurethane. 2. Wet-sand the surface with a 2000-grit sanding pad. Apply a coat of polyurethane coating with a sponge brush. Among the most durable coatings for wood protection. It can be applied using a bristle brush, foam roller, or a rag. I have heard people say that kiln drying walnut makes the grain muddy looking but I didnt want to air ... or waterbase polyurethane, which I prefer. Purists will tell you that the process is rife with challenges and demands special techniques, but with the barest determination and a little time, you can easily achieve a durable and elegant result. Do this 2 more times, then wipe the surface down with mineral spirits. To create a satin or matte finish, manufacturers add a flattening agent-- usually zinc oxide -- which disperses reflected light and cuts the gloss out of the sheen.This material collects at the bottom of the can, which is why it's important to stir well before using it. Some of these are pure tung oil, raw linseed oil, mineral oil, walnut oil, beeswax, carnauba wax, and certain shellac. These will be fairly high-traffic, so I want to be sure the tops are well protected. The color of the wood also typically remains the same with water-based polyurethane, whereas oil-based polyurethane can sometimes add a bit of color to the project. Another way to fill grain is to simply use the dust from walnut mixed with oil. Wait for the coat to dry, then sand it with 500-grit sandpaper.